581-Personal Safety / 748
P
ersonal Safet
y
BOS-PRD-03.900906
Always wear safety glasses with side shields when working with tools and similar equipment. Additional
protection using face shields may be necessary for the following types of work:
x
Grinding, chipping, sandblasting;
x
Welding.
Always wear approved hard hats, coveralls, safety footwear, suitable gloves and all other Personal
Protective Equipment (PPE) as applicable and required for the job at hand.
Refer to the PPE section in this manual for more information.
4
.
3
.
2 J
o
b
safet
y
Before beginning any work onboard, be sure that you are authorised to perform the work to be done and
inspect your tools and equipment. If a procedure is potentially hazardous to others in the area, warn fellow
workers accordingly. Use warning signs or barriers, as necessary.
Notify the
Wat
c
h Off
ic
er
if you notice any unsafe conditions such as the following:
x
Defective tools or equipment;
x
Improperly guarded machines;
x
Oil, gas, or other leaks.
Inform other employees if you see an unsafe work practice; however, be careful not to distract a person who
is working with power tools.
4
.
3
.
3
Safet
y
g
uid
el
i
nes
Follow these guidelines for general safety:
x
Know the hazards associated with your work. Be sure you are fully educated on the proper use and
operation of any tool before beginning a job;
x
Always wear appropriate safety gear and protective clothing;
x
Ensure that there is adequate ventilation to prevent exposure from vapours of paints, thinners,
chemicals and from other fumes and dust.
Maintain good housekeeping standards:
x
Keep the work area free from slipping/tripping hazards (oil, cords, debris, etc.);
x
Clean all spills immediately;
x
Remove any sawdust, wood chips, and metal chips regularly;
x
It is recommended that electrical cords pull down from an overhead pulley rather than lying on the
floor whenever this is practical onboard;
x
Leave tool and equipment guards in place;
x
Know where fire extinguishers are located and how to use them;
x
Make sure all tools and equipment are properly grounded and that cords are in good condition;
x
Double-insulated tools or those with three-wire cords are essential for safety;
x
Approved circuit breakers
should
always be used with power tools;
x
Use extension cords that are large enough for the load and distance;
x
Secure all compressed gas cylinders. Never use compressed gas to clean clothing or skin;
x
Always use flashback arrestors on cutting/welding torches;
x
Take precautions against heat stroke and heat exhaustion;
x
Wear infrared safety goggles when appropriate.
4
.
4 H
an
d
tools
Hand tools are non-powered tools. They include axes, wrenches, hammers, chisels, screw drivers, and other
hand-operated mechanisms. Even though hand tool injuries tend to be less severe than power tool injuries,
hand tool injuries are more common. Because people take everyday hand tools for granted, they forget to
follow simple precautions for safety.
Version 04. Original date: 25/05/2012. Version date: 31/12/2014. Valid version only on QMS site. Uncontrolled when printed.
Procedure prepared by: BOS Deputy QHSE Manager. Approved by: BOS QHSES Manager. Validated by: BOS Quality Representative
11 / 18
581